CPN tester high pressure common rail pump tester

CPN tester high pressure Introduction     

CPN High-pressure Common Rail Pump Tester is the special tester for the  CP1,CP2,CP3, HP0,HP2,HP3,HP4, and  pumps.

CPN tester high pressure Usage      

Fuel metering valve test

Rail pressure test for the common rail pumps

Rail pressure sensor test

CPN tester high pressure Function    

1. Could test the pump pressure and the sealing quality.

2. Could test the fuel metering valve to see the fuel flow quality.

3. Could realize the rail pressure sensor test.

4. Could realize the coil quality.

5. Could perform the on-line pressure test on start, idle, mid-speed, high-speed point of the running engine. Thus helps the technicians to judge the fault.

6. Could enforce the high pressure pump on the engine to run, to do the rush repair the fault caused by the common rail decompression valve jam.

7. Could be adapted as a common rail testing simulator to upgrade the old mechanical pump test benches.

CPN tester high pressure Specification       

Detects pump: CP1, CP2, CP3, HP0, HP2, HP3, HP4, (Note:! HP0 flow testing capabilities to be customized)

Metering valve type: normally open, normally closed

Drive current: 0-1.8A Accuracy 0.001A

Current Frequency: 165-195HZ

Response time: ≤0.1S

Rail pressure display: 0-2000Bar accuracy 1Bar

Instrument Power: AC220V

Operating temperature: -5C ° to 50C

CPN tester high pressure Parameters:

Weight: 3kg.

Size: 35*25*11cm

Voltage: 220v.

Operation temperature: -25~~50

Copyright Notice：This article belong to Shenzhen Shumatt Auto Technology Co.,ltd.All Right Reserved. If you need reprinted, pls note it from Shumatt Company, Thank you !!